7 Series E65 735i (N62) SAL
51 71 085
Removing and installing center of assembly
compartment bulkhead
Necessary preliminary tasks:
•
Remove both air ducts for microfilter
Release screw (1) on left/right and remove both fresh air ducts.
Pull off sealing strip (1).
Unfasten screws.
Place holder (2) with switch for engine hood contact to one side.
Remove bulkhead (3).
Installation:
Do not crush cable.
Check height adjustment of engine hood contact and correct if
necessary.
RA Removing and installing center of assembly compartment bulkhead
BMW AG - TIS
08.02.2013 13:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
