7 Series E65 735i (N62) SAL
61 31 019
Removing and installing (replacing) ignition
starter switch
Necessary preliminary tasks:
•
Remove audio system controller
•
Remove operator unit for heater/air conditioner
Release screws (1) of ignition starter switch (2).
Slide ignition starter switch (1) forwards and feed out in direction
of arrow.
Disconnect plug connection (2) and remove ignition starter
switch (1).
Replacement:
Carry out coding/programming.
Observe following IDC specifications:
•
Programming
•
Coding
•
Car & Key Memory
•
CD "CIP"
Version with independent heating:
Initialize all independent heating remote controls.
RA Removing and installing (replacing) ignition starter switch
BMW AG - TIS
08.02.2013 15:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
