7 Series E65 735i (N62) SAL
61 71 061
Replacing fluid reservoir for windshield
washer system
Remove front underbody protection.
Partially remove front left wheel arch trim.
Remove bottom left cover.
Note:
Washer fluid will escape when the windshield washer pump is
pulled out. Have a suitable container and cleaning cloth ready.
Observe filling capacities of fluid reservoir.
Remove level switch for windshield washer system, windshield
washer pump and if necessary washer pump of headlight cleaning
system from fluid reservoir and set to one side.
Note:
Lines remain connected.
Pull filler channel (1) out of fluid reservoir (3).
Installation:
Replace sealing ring on filler channel (1).
Detach vent hose (2) from fitting on fluid reservoir (3).
Release screws (1).
Release nut (2) and remove fluid reservoir (3) towards bottom.
Installation:
Tightening torque (screws and nuts) = 5 Nm.
RA Replacing fluid reservoir for windshield washer system
BMW AG - TIS
08.02.2013 17:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
