7 Series E65 735i (N62) SAL
67 65 010
Removing and installing or replacing drive
unit for roller sun blind
Necessary preliminary tasks:
•
Remove roller sun blind (refer to "Removing and
installing/replacing trim for parcel shelf")
Release screw (1).
Remove drive linkage (2).
Mark installation position of servodrive on bracket (3).
Installation:
Ensure correct cable routing.
Note:
Do not damage electrical lead for roller sun blind drive unit when
drilling.
Arrange bores according to dimensions (A - D) and release
screws underneath for roller sun blind drive unit.
Remove roller sun blind drive unit.
Dimensions from reference line (1):
A = 155 mm
B = 60 mm
C = 60 mm
D = 30 mm
RA Removing and installing or replacing drive unit for roller sun blind
BMW AG - TIS
08.02.2013 20:26
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -