7 Series E65 750i (N62TU) SAL
Flushing brake system completely
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Open bleeder valve and purge until clear, bubble-free brake fluid
emerges.
Close bleed valve.
Follow same procedure on rear left, front right and front left wheel
brake.
Bleeding rear-axle brake circuit
Connect bleeder hose with collecting tray to bleeder valve on rear
right brake caliper.
Close bleeder valve.
Run through bleeding routine with BMW Diagnosis and
Information System (DIS) with bleeder valve open.
After routine has finished, press brake pedal 5 times down to floor;
clear bubble-free brake fluid must flow out.
Close bleed valve.
Repeat procedure at rear left.
Bleeding front-axle brake circuit
Connect bleeder hose with collecting tray to bleeder valve on front
right brake caliper.
Close bleeder valve.
Run through bleeding routine with BMW Diagnosis and
Information System (DIS) with bleeder valve open.
After routine has finished, press brake pedal 5 times down to floor;
clear bubble-free brake fluid must flow out.
Close bleed valve.
Repeat procedure at front left.
Switch off brake fluid changer and remove from expansion tank.
Check brake fluid level.
Close expansion tank.
Note:
Take care of rubber gasket (1) in lid.
RA Bleeding brake system with DSC
BMW AG - TIS
16.02.2013 05:58
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
