7 Series E66 730Li (N52) SAL
Crank engine at central bolt in direction of rotation until a torque
converter retaining screw is visible in opening.
Release mounting bolts with special tool 24 1 110 .
Crank engine further and release remaining 2 screws.
From 03/05 with 6 converter connections.
Tightening torque 24 40 1AZ
.
Supporting transmission:
Support with special tools 24 5 306 , 24 5 301 and 00 2 030 .
Set up special tool 24 5 306 :
-
All supports to "A."
-
Supports 3 and 4 are at rear of transmission
-
Support lettering pointing forwards
Release screws (1) and nuts (2).
Remove transmission cross-member.
Tightening torque 24 71 1AZ/2AZ
.
Prepare special tool (1) 24 4 161 (A) with shaped section (2)
24 4 165 side (A) to (A).
RA Removing and installing automatic transmission (6HP19Z/N52)
BMW AG - TIS
07.02.2013 00:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -