7 Series E66 730Li (N52) SAL
-
Remove propeller shaft from transmission.
-
Release centre bearing.
-
Tie propeller shaft to one side.
Tasks are described in Removing propeller shaft.
Note:
To rotate propeller shaft, unlock parking gear.
Grip output flange (1) with special tool 23 0 020 .
Release nut with special tool 24 2 380 .
Tightening torque: 24 13 2AZ
.
Installation:
Replace nut and secure with a mandrel (8 mm) by caulking.
Detach output flange from output shaft.
Remove spacer.
Attach special tool 24 2 353 to output shaft (1).
RA Replacing output flange shaft seal (GA6HP19Z)
BMW AG - TIS
07.02.2013 00:55
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -