7 Series E66 730Li (N52) SAL
Release clamp (1) and detach cap with gaiter.
Push on new cap with gaiter.
Note:
Do not tighten down clamp (1) yet.
Mount constant-velocity joint with special tool 23 1 160 up to
stop.
Align bores of constant velocity joint and cap to each other.
Tighten down clamp on gaiter.
Note:
Keep toothing free of grease.
Inject new grease into constant velocity joint from rubber
gaiter and flange sides.
Press sealing cap with special tools 26 1 121 , 26 1 122 ,
31 2 102 and 31 2 104 into constant-velocity joint (1).
Note:
Align sealing cap and seal to bores of constant-velocity joint
with screw.
Note:
Prepare special tools 31 2 102 and 31 2 104 .
RA Replacing constant-velocity joint for propeller shaft
BMW AG - TIS
07.02.2013 01:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -