7 Series E66 730Li (N52) SAL
Unscrew nuts.
Remove shims.
If necessary, remove bracket (not shown in illustration).
Installation:
Replace self-locking nuts.
Tightening torque 32 41 9AZ
.
Note:
If necessary, raise and/or turn fluid reservoir in order to gain better
access to plug connection and hose clamps.
Disconnect plug connection at level switch.
Remove hose clamps if necessary with special tool 32 1 260 .
Disconnect suction line and radiator return line from fluid reservoir.
Lift out fluid reservoir.
Replacement:
Remove level switch.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
If necessary, carry out initial Dynamic Drive operation
RA Removing and installing / replacing fluid reservoir for power steering with Dyna
BMW AG - TIS
07.02.2013 02:03
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
