7 Series E66 730Li (N52) SAL
51 24 150
Removing and installing/replacing hydraulic
unit for rear lid actuation (from 02/2003)
(electrohydraulic-fully automatic)
Necessary preliminary tasks:
•
Have a cleaning cloth and an oil drip tray ready to catch
emerging fluid.
•
Follow notes and instructions for automatic rear lid actuation
(electrohydraulic-fully automatic).
•
Remove right luggage compartment wheel arch trim.
E67 only:
•
Remove additional trim panel.
Unscrew nuts (1).
Remove holder and pull out hydraulic unit (2).
Disconnect plug connections (3).
When removing hydraulic cylinder only:
Unhook cable holders (5) and feed out hoses (4).
Tightening torque 51 24 4AZ
.
Tightening torque 51 24 7AZ
.
When removing hydraulic unit only:
Detaching hoses on hydraulic unit:
Important!
Catch escaping fluid with a cleaning cloth/oil drip tray.
Release banjo bolts (1 and 2).
Installation:
1
Banjo bolt on hydraulic unit "RED"
2
Banjo bolt on hydraulic unit "BLUE"
3
Adhesive tape on hose is "red"
4
Adhesive tape on hose is "blue"
Tightening torque 51 24 1AZ
.
Note:
If the hydraulic unit (5) is replaced or stays removed for an
extended period of time, seal the bores in the hydraulic unit and
the hose connections for the hydraulic cylinder.
RA Removing and installing/replacing hydraulic unit for rear lid actuation (from 02
BMW AG - TIS
07.02.2013 18:02
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -