7 Series E66 730Li (N52) SAL
Necessary preliminary tasks:
•
Drawing off, evacuating and filling the A/C system are not
included in the time value given for this work operation
•
Remove alternator drive belt
•
Remove coolant thermostat
Disconnect plug connection (1).
Release screws (2, 3) and disconnect pressure and suction lines.
Installation:
Replace all sealing rings and moisten with refrigerant oil.
Tightening torque 64 52 1AZ
.
Note:
Secure compressor against falling out.
Release screws (1).
Release bolt (2) and remove with adapter sleeve behind.
Remove compressor (3) towards front.
Installation:
If necessary, replace faulty adapter sleeves.
Make sure adapter sleeve is correctly fitted.
Tightening torque 64 52 3AZ
.
After installation:
•
Evacuate and fill A/C system
•
Add coolant
•
Check cooling system for leaks
RA Replacing compressor for air-conditioning system (N52)
BMW AG - TIS
07.02.2013 23:29
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
