7 Series E66 735Li (N62) SAL
Installation:
Clean seal residue from sealing surfaces.
Apply a thin, uniform bead of Drei Bond 1209 sealing agent
(refer to BMW Parts Service) to transition area of half-moon
sections.
Replace sealing elements (1).
Installation:
Make sure gasket is correctly seated at sides and on rear side of
cylinder head.
Installation:
Screw connections (1, 2, 3 and 4) of cylinder head cover are
different.
Replace screw connections (3).
Insert screw connections (1, 2 and 3) without pretension and
align cover.
Tighten down screw connections (1, 2 and 3) in diagonal
sequence from inside to outside.
RA Removing and installing/sealing left cylinder head cover (N62/N62TU)
BMW AG - TIS
08.02.2013 17:13
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -