bmw Workshop Repair Guides

BMW 7 Series E66 735Li Workshop Service and Auto Repair Manual

ABOUT US
2 RA Removing And Installing_replacing Oil Sump Bottom Section (N62_N62TU) > < 1 RA Removing And Installing_replacing Oil Sump Top Section (N62_N62TU)

Removing and Installing Oil Sump Top Section for 7 Series E66 735Li

Page 2
background image

Installation:

Check fluid level in automatic
transmission; top up if necessary.

Unclip cable duct of oxygen sensors from automatic transmission.

Release screw, remove tensioner (1) from A/C compressor drive
belt (E65 only).

Unfasten screws.

Release screws and remove oil sump top section.

Installation:

Replace sealing ring on dipstick guide tube.

Free sealing faces of seal debris and clean.

1. 

Replace gasket.

2. 

Install oil sump.

3. 

Insert all screws on transmission end,

4. 

Tighten down all screws on oil sump.

Tightening torque 11 13 2AZ

.

RA  Removing and installing/replacing oil sump top section (N62/N62TU)

BMW AG - TIS

08.02.2013  17:20

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 2 -

2 RA Removing And Installing_replacing Oil Sump Bottom Section (N62_N62TU) > < 1 RA Removing And Installing_replacing Oil Sump Top Section (N62_N62TU)