7 Series E66 735Li (N62) SAL
Attach special tool 11 9 490 to second end of torsion spring.
Support end of torsion spring protected with special tool
11 9 490 on inlet camshaft.
Release screw (1).
Remove torsion spring (1) and special tool
11 9 490 .
Remove intermediate levers and torsion springs of
cylinders 1 to 3 according to the same procedure and set down
in an orderly fashion.
RA Removing and installing/replacing right inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
08.02.2013 17:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -