7 Series E66 735Li (N62) SAL
Place bearing bracket (1) with inlet camshaft and eccentric shaft
as illustrated on special tool 11 9 470 .
Secure bearing bracket (1) with a nut (special tool 11 9 473 ).
Important!
The lower section of the bearing bracket (1) is machined with
the cylinder head and must not be mixed up.
Note:
Lower section of bearing bracket (1) remains on cylinder head.
Note:
This work step will only be necessary if after the inlet camshaft
has been removed the eccentric shaft is also to be removed.
If necessary, remove eccentric shaft sensor (2).
Note:
Removal of the intermediate levers and torsion springs is
described on the 4th cylinder. The same procedure is applicable
to cylinders 1 to 3.
Raise one end of torsion spring (1) with special tool
11 9 480 .
Lift out intermediate lever (2) and set down in an orderly fashion.
Important!
Keep holding torsion spring (1) with special tool 11 9 480 .
RA Removing and installing/replacing right inlet camshaft (N62 to 9/03)
BMW AG - TIS
08.02.2013 17:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -