7 Series E66 735Li (N62) SAL
![background image](/bmw/7_Series_E66/735Li_N62_SAL/page-209005.png)
Install rocker arms (1) on inlet side.
Important!
Rocker arms (1) slip slightly when bearing bracket is fitted.
Make sure rocker arms (1) are secured as illustrated on
hydraulic valve clearance compensating elements and on
valves.
Align rocker arms (1) straight.
Remove special tool 11 9 473 .
Remove bearing bracket (1) from special tool 11 9 470 .
Important!
Do not tilt bearing bracket (1).
Lower bearing bracket (1) from above and carefully bring into
contact with cylinder head.
Insert nuts and tighten by hand without play.
Important!
Make sure none of the intermediate levers or rocker arms
have slipped out.
Tighten down nuts from inside to outside.
Tightening torque, 11 31 1AZ .
Important!
Do not mix up the camshaft bearing covers of
cylinders 1 to 4 and 5 to 8.
Fit bearing cap R E1 in such a way that marking is legible from
inlet side.
Install nuts and tighten down.
Tightening torque, 11 31 1AZ .
RA Removing and installing/replacing rocker arms on left inlet side (N62 to 9/03)
BMW AG - TIS
08.02.2013 17:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -