7 Series E66 735Li (N62) SAL
11 37 008
Removing and installing/replacing right
eccentric shaft (N62 to 9/03)
(cylinder bank 1 to 4)
Remove servomotor for right eccentric shaft.
Remove ignition coils on cylinder bank 1 to 4.
Remove spark plugs on cylinder bank 1 to 4.
Remove right cylinder head cover.
Install inlet and exhaust adjustment unit on right side.
Remove right inlet camshaft.
Important!
Eccentric shafts up to 2/2003:
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are
different and must not be mixed up. The side of the eccentric
shaft on which the lever for the torsion spring is fitted must not
be mixed up.
Eccentric shafts from 2/2003:
Eccentric shafts of cylinders 1 to 4 and 5 to 8 are
identical parts.
Depending on the side on which the lever for the torsion
spring and the magnet wheel are fitted, the eccentric shafts
are used for cylinders 1 to 4 or 5 to 8.
Removal
Removal of eccentric shaft is described separately from
installation.
RA Removing and installing/replacing right eccentric shaft (N62 to 9/03)
BMW AG - TIS
08.02.2013 17:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -