7 Series E66 735Li (N62) SAL
Important!
Intermediate levers (2) are divided into individual tolerance
classes.
Only intermediate levers of the same tolerance class may be
fitted in a single cylinder head.
The tolerance classes are designated as illustrated with the
numbers from 1 to 5.
Used intermediate levers (2) may only be reused in the same
position.
Raise second end of torsion spring (1) with special tool
11 9 480 .
Lift out intermediate lever (2) and set down in an orderly fashion.
Important!
Keep holding torsion spring (1) with special tool 11 9 480 .
Attach special tool 11 9 490 to second end of torsion spring.
Support end of torsion spring protected with special tool
11 9 490 on inlet camshaft.
Installation:
Installation of intermediate levers is described separately from
removal.
Clean all bearings and cams of inlet camshaft and lubricate with
engine oil.
RA Removing and installing/replacing left intermediate levers (N62 from 9/03 and N6
BMW AG - TIS
08.02.2013 17:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -