7 Series E66 735Li (N62) SAL
Release nut and remove hydraulic hose (1) with holder from
mounting.
Pull spring clamp (1) downwards.
Remove heat exchanger (3).
Unlock hydraulic lines (1 and 2) on heat exchanger (3) with
special tool 17 0 030 and disconnect.
Installation:
Connect hydraulic line (2) with TOP marking to upper pipe of
heat exchanger.
Caution!
Check fluid level in automatic transmission,
refer to Maintenance and General Information MG00.
RA Removing and installing/replacing heat exchanger for automatic transmission (N62
BMW AG - TIS
08.02.2013 19:15
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
