7 Series E66 735Li (N62) SAL
Insert special tool 24 4 160 into opening of transmission housing
and clamp gently with screw (1).
Twist in screw (2) and clamp down.
Then tighten down screw (1) briefly.
Further tasks:
Remove transmission cross-member.
Tightening torque 24 71 1AZ/2AZ
.
N73 only:
Release holder so that lines of power steering (1) do not collide
with line from transmission oil cooler (2).
Remove propeller shaft:
-
Remove propeller shaft from transmission.
-
Release center bearing.
-
Tie propeller shaft to one side.
If necessary, unlock or lock transmission lock.
Note:
Support front of engine on housing with an assembly aid (e.g.
transmission lifter) when removing and installing transmission.
RA Removing and installing automatic transmission (6HP26Z/6HP32Z)
BMW AG - TIS
08.02.2013 19:32
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 6 -