7 Series E66 735Li (N62) SAL
Version with Dynamic Drive:
Draw off and dispose off hydraulic fluid from fluid reservoir.
Observe country-specific waste-disposal regulations
Remove bottom right wheel arch trim.
Remove underbody panelling cover on right.
Release nut (1) for Dynamic Drive pressure line.
Tightening torque 37 14 13AZ
.
Release nut (2) for Dynamic Drive return line.
Tightening torque 37 14 21AZ
.
Release nuts (3) for pressure lines to front axle oscillating motor.
Tightening torque 37 14 13AZ
.
If necessary, position special tool 00 2 040 with a 2nd person
helping on workshop jack 00 2 030 .
Insert special tools 31 4 011 and 31 4 012 into corresponding
mountings of special tool 00 2 040 .
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
Align special tool 00 2 040 to front axle carrier.
Note:
Make sure when raising that special tools 31 4 011 and
31 4 012 are correctly inserted in the front or rear recesses on
the front axle carrier.
If necessary, lower special tool 33 3 274 .
Support front axle carrier by raising special tool 00 2 040 .
RA Lowering/raising front axle carrier
BMW AG - TIS
08.02.2013 19:57
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -