7 Series E66 735Li (N62) SAL
Assembly:
Accommodate coil spring with special tools 31 3 352 .
Twist coil spring until lower end of coil spring (1) is flush with
end (2) of special tool 31 3 352 .
Warning!
Do not compress coil spring to full extent.
Coils of coil spring must be located completely in recesses of
special tools 31 3 352 !
Tension coil spring.
Check auxiliary damper and spring pad for damage, replace if
necessary.
Note:
Align spring pad by way of recess to spring plate.
Insert shock absorber in tensioned coil spring.
Check support bearing, spring plate with bearing, spring pad and
gaiter for damage, replace if necessary.
Attach spring plate with bearing and spring pad to piston rod.
Check support bearing for damage, replace if necessary.
Attach support bearing and joint seat to piston rod.
Replace nut and tighten down (gripping piston rod in so doing).
Tightening torque 31 31 2AZ
.
Important!
Upper coil of coil spring must rest positively on spring plate!
Lower end of coil spring must rest on stop of spring pad!
Relieve tension on coil spring.
Check installation position of gaiter, correct fold if necessary.
RA Replacing front left or right spring strut (standard suspension)
BMW AG - TIS
08.02.2013 20:04
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
