7 Series E66 735Li (N62) SAL
Insert special tools 33 4 227 and 33 4 228 into corresponding
mountings of special tool 00 2 040 .
Warning!
Danger of injury!
Failure to comply with the following instructions may result
in the vehicle slipping off the lifting platform and critically
injuring other persons.
When supporting components, make sure that
•
the vehicle can no longer be raised or lowered
•
the vehicle does not lift off the locating plates on the
lifting platform
Align special tool 00 2 040 to rear axle carrier.
If necessary, lower special tool 33 3 274 .
Support rear axle carrier by raising special tool 00 2 040 .
Version with Dynamic Drive: Disconnect pressure lines at point of
separation II and seal with plugs.
Remove tension strut on both sides with heat shield.
Remove wheel arch cover on both sides from stop disc.
RA Removing and installing complete rear axle carrier
BMW AG - TIS
08.02.2013 21:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -