7 Series E66 735Li (N62) SAL
34 51 527
Removing and installing/replacing DSC
hydraulic unit
Note:
Read and comply with General Information.
Observe safety instructions on raising the vehicle.
After completing work: Bleed braking system
Press clutch pedal down to floor and secure with pedal support.
Note:
The pedal support may only be released when the brake lines are
reconnected.
This prevents brake fluid from emerging from the expansion tank
and air from entering the system when the brake lines are opened.
Release coolant expansion tank (1) and place to one side
Not for vehicles with M67 engines.
Important!
Do not mix up brake pipes (mark if necessary).
Do not bend brake lines.
Unfasten brake lines.
Installation:
Tightening torque 34 32 1AZ
.
Line connections:
(F) From brake master cylinder, circuit F, to hydraulic unit, circuit
F (front-axle brake circuit)
RA Removing and installing/replacing DSC hydraulic unit
BMW AG - TIS
08.02.2013 22:05
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
