Pressure Lines for Oscillating Motor - BMW 7 Series E66 735Li (N62) SAL
Mark installation position of pressure lines to oscillating motor.
Release nuts (1).
Remove pressure lines from oscillating motor.
Installation:
Carry over identification to new component.
Pressure lines are protected against being mixed up by different
thread diameters on the oscillating motor connection.
Tightening torque 37 14 18AZ
.
Feed pressure lines (1, 2) out of front axle carrier.
Installation:
Make sure pressure lines are laid without tension and with
sufficient spacing to adjoining components.
RA Removing and installing/replacing pressure lines for oscillating motor/front axl
BMW AG - TIS
08.02.2013 22:38
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 3 -