7 Series E66 735Li (N62) SAL
51 14 110
Removing and installing/replacing rear model
designation (up to 03/2005)
Important!
The "Instructions for number/letter combination cementing"
serve as the basis for these repair instructions and must be
followed without fail.
Fitting dimensions (E65, E66, E67):
Attach adhesive tape (1) to rear lid above rear fog light (2) up to top edge "A". Mark measurement "B" from
outermost corner point of rear fog light (2) on adhesive tape (1).
Dimensions:
A = 16 mm
B = 35 mm
Note:
Measurements C, D, E and F are for information purposes only, as determined by carrier film.
C = 8 mm, D = 10 mm, E = 16 mm, F = 26 mm
RA Removing and installing/replacing rear model designation (up to 03/2005)
BMW AG - TIS
09.02.2013 00:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
