bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

5 RA Removing And Installing_replacing Function Carrier On Left Or Right Front Door|Page 1881 > < 4 RA Adjusting Front Left Or Right Door Detent (lock Wedge)
Page 1
background image

51 21 035

Removing and installing/replacing function
carrier on left or right front door

Necessary preliminary tasks:

Remove front door trim panel

Important!

Risk of mixing up plugs for door lock and control unit!

Mark relevant plugs prior to removal.

Disconnect Bowden cable (1).

Disconnect plug connections (2).

Disconnect cable holder (3); if necessary, release cable tie.

Feed out door wiring harness through wiring harness opening (4).

Release quick-release couplings.

Remove function carrier.

Installation:

If necessary, replace defective quick-release couplings.

Make sure quick-release couplings are installed in correct
position.

Quick-release coupling 1.8 mm grey

Quick-release coupling 0.8 mm white

RA  Removing and installing/replacing function carrier on left or right front door

BMW AG - TIS

09.02.2013  00:41

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

5 RA Removing And Installing_replacing Function Carrier On Left Or Right Front Door|Page 1881 > < 4 RA Adjusting Front Left Or Right Door Detent (lock Wedge)