7 Series E66 735Li (N62) SAL
67 31 610
Removing and installing/replacing drive for
seat tilt adjustment (comfort seats in rear
compartment)
Remove rear seat padding completely.
Disconnect plug connection (1). If necessary, cut through cable
tie.
Release screws (2).
Detach drive for seat tilt adjustment (3) from drive shaft (4) and
feed out in direction of arrow.
Installation:
Make sure drive shaft (4) is correctly seated.
Replacement:
Initialize drive unit for seat tilt adjustment.
RA Removing and installing/replacing drive for seat tilt adjustment (comfort seats
BMW AG - TIS
09.02.2013 07:56
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
