7 Series E66 735Li (N62) SAL
67 64 010
Removing and installing/replacing drive unit
for electric steering column adjustment
Necessary preliminary tasks:
•
Move steering column into "lower" and "extended" position
•
Disconnect battery negative lead
•
Remove panel for active knee protection, left
Note:
For purposes of clarity, graphic shows steering column removed.
Unlock plug housings (1) and remove from holder (2) in
direction of arrow.
Disconnect plug connections (3).
Important!
Do not bend or twist drive shafts when removing!
Release screws (3) and feed out drive (1) in direction of arrow.
Installation:
Replace screws (3).
Tightening torque 32 31 12AZ
.
Installation:
Drive shafts must be inserted exactly in guides (2).
Check plastic bearings (1), replace if necessary.
RA Removing and installing/replacing drive unit for electric steering column adjust
BMW AG - TIS
09.02.2013 08:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
