7 Series E66 735Li (N62) SAL
When this is done, the tailgate is fully opened by the force of a spring or by the automatic tailgate actuation
(optional).
An ID transmitter inside the vehicle on the rear window shelf will also be recognised.
Passive Go
In order to switch the terminal and/or start up the engine, the ID transmitter must simply be located inside the
vehicle (not necessarily in the insert compartment).
Engine start is not possible if an ID transmitter is detected inside the luggage compartment.
In principle, the authenticity check required is the same as that for Passive Entry (except that it is run via the
interior aerials).
An ID transmitter must be located inside the vehicle when the START/STOP button is pressed. Otherwise, the
instrument cluster will display a Check-Control message.
Press the START/STOP button to switch the terminals. The terminal switching sequence is as follows: 0 =>
Terminal R => Terminal 15 => Terminal R => 0.
The START/STOP button must be pressed for approximately 500 ms in order to start up the engine. On
vehicles with automatic transmission, the brake pedal must be depressed at the same time.
The engine may be started up in any terminal position.
Once the engine has been switched off, it may be restarted within 5 seconds even if no ID transmitter is
detected inside the vehicle (i.e. no valid drive authorisation). This safety measure is required for possible
emergencies.
Passive Exit
The outside door handle must be pressed to lock the vehicle and activate the anti-theft alarm.
If the outside door handle is pressed for approximately 3 seconds to lock the vehicle, the auto-remote closing
(closing of the side windows or sliding/tilting sunroof and, if applicable, folding in of the door mirrors) is activated.
Auto-remote opening via the outside door handle is not possible.
Terminal R is deactivated when the outside door handle is locked.
Terminal 15 is not deactivated when the vehicle is locked. A Check-Control message appears as a warning
when the driver's door is opened with terminal 15 ON.
Special feature: Comfort Access allows the vehicle to be locked whilst the engine is running.
Disabling an ID transmitter located inside the vehicle
When the vehicle is closed via the outside door handle, any ID transmitter inside the vehicle will be detected.
This ID transmitter is disabled for all Comfort Access functions.
However, it is still possible to access the luggage compartment. The ID transmitter is reactivated when the
vehicle is unlocked again.
Disabling an opposing command
When the vehicle is unlocked via the outside door handle, it cannot be locked again for approx. 2 seconds.
Similarly, when the vehicle is locked via the outside door handle, it cannot be unlocked again for approximately 2
seconds.
This allows the user to pull on the outside door handle to check that the vehicle is actually locked.
Tamper-proof lock
The vehicle may only be locked and unlocked consecutively a maximum of 8 times. After this, the tamper-proof
SBT Comfort Access E65, E66
BMW AG - TIS
09.02.2013 13:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 5 -
