7 Series E66 745Li (N62) SAL
Note:
Illustration with engine removed.
Detach hose (1) on check valve (4).
Unfasten screws (2).
Important!
A spacer bushing is secured with screw (3) behind tube (5).
Release screw (3) and remove check valve (4), tube (5) and
spacer bushing.
Unclip cables (6 and 7).
Installation:
Replace sealing ring on tube (5) and coat with antiseize agent.
Removal:
Removal of cylinder head is described separately from installation.
Remove inlet and exhaust adjustment unit on right side.
Slacken off chain tensioning piston (1) by approx. one turn.
Note:
Illustration with engine removed.
Remove eccentric shaft sensor (2).
RA Removing and installing right cylinder head (N62 from 9/03 and N62TU)
BMW AG - TIS
11.02.2013 06:34
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
