7 Series E66 745Li (N62) SAL
11 13 010
Removing and installing/replacing oil sump
top section (N62/N62TU)
Special tools required:
•
17 0 030
Work step
Note:
Remove design cover
Remove center front panel
Remove fan clutch (E65 only)
Remove fan cowl (E65 only)
Remove electric fan (E60 only)
Remove alternator drive belt
Remove A/C compressor drive belt
Remove acoustic cover
Secure engine in installation position with special tool
Release nuts on left and right engine mounts at top
Remove reinforcement plate
Drain off engine oil
Remove lower oil sump section
Lower front axle support
Note:
To remove the oil sump, you
must lower the front axle
support.
There is no need to perform a
front axle alignment check.
Release power steering pump on bracket, hydraulic lines remain connected.
Secure power steering pump against falling down.
Unlock and disconnect hydraulic lines from heat exchanger with special
tool 17 0 030 .
Release hydraulic lines on automatic transmission.
Release holder for hydraulic lines. Remove hydraulic lines.
Installation location: on radiator at
bottom left.
Transmission fluid emerges when
hydraulic lines are released.
Catch and dispose of escaping
transmission fluid.
RA Removing and installing/replacing oil sump top section (N62/N62TU)
BMW AG - TIS
11.02.2013 06:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
