7 Series E66 745Li (N62) SAL
Important!
Camshaft bearing caps of cylinders 1 to 4 and 5 to 8 must
not be mixed up.
Note:
Bearing caps of inlet camshaft are marked on cylinder bank 5
to 8 with R E1 to R E5 from inlet side.
Release nuts and remove bearing cap R E1.
Release 8 nuts of bearing bracket (1) from outside to inside.
Note:
Rocker arms are freely accessible after bearing bracket has been
removed.
Do "not" remove rocker arm (1) on inlet side.
Important!
Rocker arms (1) are divided into individual tolerance classes.
The tolerance classes are designated as illustrated with the
numbers from 1 to 4.
Used rocker arms (1) may only be reused in the same
position.
When replacing rocker arms (1) on inlet side: install rocker arms
of the same tolerance class in the same position.
Clamp special tool 11 9 470 as illustrated in a vice.
RA Removing and installing/replacing left inlet camshaft (N62 from 9/03 and N62TU)
BMW AG - TIS
11.02.2013 06:52
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
