7 Series E66 745Li (N62) SAL
11 37 035
Removing and installing/replacing left
eccentric shaft sensor (N62/N62TU)
(cylinder bank 5 to 8)
Necessary preliminary tasks:
•
Remove left cylinder head cover
Unfasten screws.
Remove eccentric shaft sensor (1).
Installation:
Read out fault memory of control unit of Digital Motor Electronics
(DME).
Check stored fault messages.
Rectify faults.
Now clear the fault memory.
RA Removing and installing/replacing left eccentric shaft sensor (N62/N62TU)
BMW AG - TIS
11.02.2013 07:18
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
