7 Series E66 745Li (N62) SAL
32 41 060
Removing and installing vane pump (N62) for
power steering (up to 10 / 2003)
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
Observe country-specific waste-disposal regulations
•
Remove drive belt
•
Remove front assembly underside protection
Release hose clamp and detach suction line (1) from vane pump.
Installation:
Align suction line (1) by way of marking to connection on vane
pump.
Release nut and disconnect pressure line (2) from vane pump.
Installation:
Replace sealing ring.
Make sure hydraulic lines are laid without tension and with
sufficient spacing to adjoining components.
Tightening torque 32 41 3AZ
.
RA Removing and installing vane pump (N62) for power steering (up to 10 / 2003)
BMW AG - TIS
11.02.2013 10:11
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
