7 Series E66 745Li (N62) SAL
Open weld joints in areas (1).
Remove side luggage compartment floor (2).
Mark severance cut on longitudinal member in accordance with
measurement a and cut completely.
Measurement a = approx. 100 mm from rear M6 thread.
Installation:
Weld in reinforcing plate approx. 40 mm long.
Open weld joints in areas (1).
Preparation of new part:
Mark new luggage compartment floor part in accordance with
previous severance cuts and cut.
Installation information:
Adjust luggage compartment floor to fit with straightening
attachment or universal mount.
Before welding in, also adjust tail panel, rear lid and rear lights to
fit.
Cut new wheel arch extension part 20 mm above edge (1).
RA Replacing complete rear luggage compartment floor (tail panel removed)
BMW AG - TIS
11.02.2013 12:33
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
