7 Series E66 745Li (N62) SAL
Release plastic nut (1).
Feed cover strip (2) forwards and upwards out of trim (3) if
necessary with aid of fishbone 00 9 321 and remove.
If necessary, lever clips with end cutting pliers (head of pliers
surface-ground) out of door pillar.
Note:
If necessary, detach mucket before removing trim on rear comfort
seat.
Installation:
Feed in guide lugs (1) under trim (2).
Installation:
If necessary, replace faulty clips (1).
Clip mounts of entrance cover strip (2) must not be
damaged.
Push clips (1) onto entrance cover strip (2).
RA Removing and installing/replacing entrance cover strip, rear (inside) left or ri
BMW AG - TIS
11.02.2013 15:31
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
