7 Series E66 745Li (N62) SAL
Lift cover (1) upwards slightly.
Pull tube (2) out of cover (1).
Remove line (3) together with rubber seal from cover (1).
Unclip line (2) from holders (1).
Removing cowl panel cover
Installation:
If necessary, replace defective grommets (1).
Check holder (2) for correct seating.
Installation:
Clips (1) must not be missing or damaged.
Apply some butyl (sourcing reference: BMW Parts Service) in
corners of cover (2) in area (3):
-
Width 3 mm
-
Length approx. 6 cm.
Remove excess butyl from windscreen.
RA Removing and installing / replacing cowl panel cover
BMW AG - TIS
11.02.2013 15:40
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
