7 Series E66 745Li (N62) SAL
61 31 382
Replacing level switch for coolant
Warning!
Danger of scalding!
Only perform this work after engine has cooled down.
Release screws (1).
Pull expansion tank (2) in direction of arrow out of grommet (3)
underneath and place to one side.
Installation:
Make sure expansion tank (2) is correctly seated in
grommet (3).
If necessary, replace grommet (3).
Disconnect plug connection (4).
Note:
For purposes of clarity, illustration shows expansion tank (2)
removed.
Important!
Do not damage connected water hoses.
Reposition expansion tank as far as possible until coolant
level switch (2) forms the highest point. This will prevent
coolant from escaping on opening.
If necessary, catch escaping coolant and feed back in later.
Turn coolant level switch (1) in direction of arrow, pull downwards
out of expansion tank (2) and remove.
RA Replacing level switch for coolant
BMW AG - TIS
11.02.2013 17:44
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
