X Series E53 X5 3.0d (M57) OFFRD
Install pressure accumulator (4).
Install and tighten down screws (3).
Install pressure line (1) and tighten down with special tool
13 5 020 .
Tightening torque, 13 53 8AZ
.
Installation:
Make sure rubber mount (2) is correctly positioned.
Place timing chain (2) on inlet sprocket wheel (3).
Push inlet sprocket wheel (3) onto inlet camshaft.
Insert Torx bolt (1), initially tighten and then slacken again by a
half turn.
Note:
The position of the sprocket wheel to the camshaft does not
influence the function in any way.
Place timing chain (1) on exhaust sprocket wheel (2).
Push exhaust sprocket wheel (2) onto exhaust camshaft.
Insert Torx bolt.
Note:
The position of the sprocket wheel to the camshaft does not
influence the function in any way.
Installation:
Make sure profile gasket (1) of guide rail (2) is correctly
positioned.
RA Removing and installing cylinder head (M57)
BMW AG - TIS
03.02.2013 18:45
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 15 -
