X Series E53 X5 3.0d (M57) OFFRD
32 13 061
Replacing power steering gear
Important!
Adhere to the utmost cleanliness. Do not allow any dirt to
enter the hydraulic system.
Seal off pipe connections with plugs.
After installation:
•
Fill and bleed hydraulic system
•
Check pipe connections for leaks
•
Perform chassis alignment check
•
Carry out steering angle sensor adjustment
Necessary preliminary tasks:
•
Draw off and dispose off hydraulic fluid from fluid reservoir
Observe country-specific waste-disposal regulations
•
Remove front wheels
•
Remove underbody protection
•
Remove reinforcement plate
•
Move engine into installation position, raise and secure (refer
to Removing oil sump)
•
Remove tie rod end on both sides
•
Remove double joint from power steering gear
Unfasten screws.
Installation:
Replace screws and self-locking nuts.
Tightening torque 32 00 1AZ
.
Check distance between engine carrier and stem of double joint!
RA Replacing power steering gear
BMW AG - TIS
03.02.2013 22:19
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -