X Series E53 X5 3.0i (M54) OFFRD
VS-21/Seyfried
Baugruppe/Group: 00
00 15 01 (752)
weltweit
all countries
Datum/Date:
Checking ribbed V-belt
E53 / M54, M57, M62
Situation:
Extreme operating conditions - frequent off-road driving with fording and driving through
mud, frequent operation in dusty or sandy terrain - can result in an unusually high degree of
wear on the ribbed V-belt (main drive).
Effect:
In unfavorable circumstances, a worn ribbed V-belt could slip briefly during fording of if it is
splashed with water.
Affected vehicles:
E53/M54, M57, M62 B44, M62 B46
Manufacturing period: throughout series production
Action:
On vehicles that have frequently been driven under extreme operating conditions, it is
advisable to check the ribbed V-belt (main drive), and to replace it as necessary, during
each engine oil service.
A general revision or supplement to the scope of maintenance work will not be made.
Procedure:
-
Remove ribbed V-belt - please refer to repair instructions, job item 11 28 010
-
Measure the thickness (H
0
) of the ribbed V-belt (see illustration).
Measure the thickness (H
1
) of the "folded" ribbed V-belt (see illustration).
Figure:
H
0
= Thickness of straight ribbed V-belt
H
1
= Thickness of "folded" ribbed V-belt
-
The ribbed V-belt must be replaced if the measured value for H
1
is below the value
given in the table below, which will depend on H
0
:
H
0
H
1
4.6
< 7.4
4.7
< 7.6
4.8
< 7.8
4.9
< 8.0
5.0
< 8.2
SI Checking ribbed V-belt E53 M54 M57 M62
BMW AG - TIS
06.02.2013 09:09
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -