X Series E53 X5 3.0i (M54) OFFRD
Lines remain connected.
Drain and dispose of coolant.
Note:
The water drain plug is located on the exhaust side on
cylinder 2 in the engine block.
Installation:
Replace sealing ring of water drain plug.
Tightening torque 11 11 5AZ.
Pull locks (1) and disconnect water hoses.
Installation:
Refer to general instructions for work on cooling system.
Remove radiator.
Remove intake air manifold.
Disconnect water hoses from water pipe and from heating valve.
Release wiring harness section for engine and lay to one side.
Draw off hydraulic fluid from supply tank for power steering pump.
Dispose of hydraulic fluid.
Observe country-specific waste-disposal regulations.
Unfasten reservoir for power steering unit and tie up to one side.
Note:
Lines remain connected.
RA Removing and installing engine (M54)
BMW AG - TIS
06.02.2013 11:07
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -
