X Series E53 X5 3.0i (M54) OFFRD
Remove left and right swivel bearings.
Remove output shafts.
Remove propeller shaft at front.
Remove alternator drive belt from belt pulley for vane pump.
Remove vane pump for power steering.
Note:
Lines remain connected.
Tie vane pump to one side.
Open oil drain plug and drain off engine oil.
Disconnect return hose from oil separator.
Remove guide pipe for dipstick.
Installation:
Replace O-ring.
Unfasten steering spindle from steering gear. This operation is
described in the section "Removing and installing steering gear".
Provisionally reinstall left and right swivel bearings and connect
with a screw to spring strut.
Provisionally connect tension strut, control arm and tie rod to
swivel bearing.
RA Removing and installing/replacing oil sump (M54)
BMW AG - TIS
06.02.2013 16:30
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 4 -
