bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

17 Cooling System (M54) > < 2 RA Removing And Installing_replacing Dust Filter For Tank Leakage Diagnosis Module
Page 1
background image

16 14 530

Replacing suction jet pump(s)

Draw off fuel from fuel tank,

refer to 16 00 005

Remove sensor from left fuel level indicator,

refer to 16 12 001

Remove sensor from right fuel level indicator,

refer to 16 12 000

Right side

Lift line (3) out of holder (4).

Pull lines (1) + (2) to left out of holder (5).

Installation:

Lines (1) + (2) must noticeably snap into place when fitted in
holder (5).

Left side

Feed suction jet pump out of fuel tank and pull out towards top.

Installation:

Carefully feed in lines of suction jet pumps, do not kink.

It is absolutely essential to ensure that line set for suction jet
pumps is correctly positioned in fuel tank!

1. 

Suction jet pump in fuel tank, rear left

2. 

Suction jet pump in fuel tank, front left

3. 

Line ends for right side of fuel tank.

4. 

Connection of line set to sensor unit, left.

RA  Replacing suction jet pump(s)

BMW AG - TIS

06.02.2013  17:47

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

17 Cooling System (M54) > < 2 RA Removing And Installing_replacing Dust Filter For Tank Leakage Diagnosis Module