X Series E53 X5 3.0i (M54) OFFRD
Assemble special tool 33 4 140 with 33 4 148 and
33 4 149 .
Note:
Mount special tool 33 4 149 in accordance with the diameter of
the rubber mount.
Letter A = dia. 80 mm
Letter B = dia. 95 mm
Unscrew feed handle (1). If necessary, mount extension
piece (3) on special tool 33 4 145 with new screw (2).
Fit special tools 33 4 140 , 33 4 155 , 33 4 156 , 33 4 158
on openings in rubber mount.
Note:
Ensure it is correctly supported on bushing of rear axle carrier.
Using a hot air blower, heat bearing bushing at max. 600
°
C outlet
temperature for approx. 2 minutes.
Pull out rubber mount by turning special tool 33 4 155 .
Coat rubber mount with Circolight anti-friction agent.
Important!
Arrows (1) or stops (2) of inner sleeve must point in vehicle
longitudinal direction (F) when rubber mount is installed. A
maximum deviation (A) of
±
7
°
must be observed.
RA Replacing all rubber mounts for rear axle carrier
BMW AG - TIS
06.02.2013 20:54
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 2 -