X Series E53 X5 3.0i (M54) OFFRD
51 21 170
Removing and installing or replacing outside
handle from left or right front door
Driver's side:
Remove lock cylinder completely from front door.
Passenger side:
Remove cover on outside handle.
Removal:
Slacken nut (1) on outside handle (2) (do not release fully).
Installation:
Contact surface (3) of outside handle (2) must rest without play
against lock actuator (4).
Tightening torque, 51 21 5AZ.
Note:
Fit the older outer frame (1) of screw cover (damage to paint).
Pull outside handle (2) as far outwards/upwards as possible and
secure in this position with a screwdriver (3).
Note:
For removal, the outside handle (1) must remain secured with a
screwdriver (3).
A
Pull off outside handle (1) from rear lock actuator (2).
B
Pull off outside handle (1) in lowest setting (as shown in
illustration) from front lock actuator (4).
RA Removing and installing or replacing outside handle from left or right front doo
BMW AG - TIS
06.02.2013 23:39
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
