bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

1 RA Removing And Installing_replacing Lower Trim For Rear Lid Upper Section|Page 2163 > < 3 RA Removing And Installing_replacing Insulation Lining On Hood_bonnet
Page 1
background image

51 49 050

Removing and installing/replacing lower trim
for rear lid upper section

Special tools required:

00 9 317

Remove trunk lamps (in rear lid upper section).

Using special tool  00 9 317 , lever out side trim (1) on left/right
with clip (2) from retainer (3) in lower trim (4).

Installation:

If necessary, replace faulty retainer (5).

Remove protective caps (1) and release screws underneath.

Release screws (2).

Lever out side trims (3) and clip out lower trim (4).

Feed emergency actuator (5) out of trim (4).

RA  Removing and installing/replacing lower trim for rear lid upper section

BMW AG - TIS

07.02.2013  00:39

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

1 RA Removing And Installing_replacing Lower Trim For Rear Lid Upper Section|Page 2163 > < 3 RA Removing And Installing_replacing Insulation Lining On Hood_bonnet