X Series E53 X5 4.4i (M62) OFFRD
11 12 004
Removing and installing/sealing both cylinder
head covers (M62)
Instructions for disconnecting and connecting battery,
refer to General Information MG12.
Disconnect battery negative terminal.
"Remove heater bulkhead",
refer to 51 71 080.
Turn fasteners on acoustic cover 90
°
counterclockwise, remove
acoustic cover.
Release bellows on throttle. Remove upper section of suction filter
housing with mass air flow sensor. Remove lower section of
suction filter housing.
Detach battery positive lead from support point on firewall. Feed
out battery positive lead and lay to one side.
Cylinder head cover of cylinder bank 1 to 4:
Remove washer fluid reservoir.
Cylinder head cover of cylinder bank 5 to 8:
Unclip water hoses from holder on heater valve and press to one
side.
Note:
Water pipes remain connected.
RA Removing and installing/sealing both cylinder head covers (M62)
BMW AG - TIS
08.02.2013 01:36
Issue status (12/2007) Valid only until next DVD is issued
Copyright
Page - 1 -
