bmw Workshop Repair Guides

BMW Workshop Service and Repair Manuals

3 RA Removing And Installing Timing Case Cover, Bottom (M62 VANOS From 9_98)|Page 466 > < 2 RA Removing And Installing Timing Case Cover, Top Right (M62 VANOS From 9_98)|Page 464
Page 1
background image

11 14 110

Removing and installing timing case cover,
bottom (M62 VANOS from 9/98)

Instructions for disconnecting and connecting battery,

refer to General Information MG 12.

Disconnect negative battery lead.

Unfasten drain plug for coolant on right engine block.

Drain and dispose of coolant.

Installation:

Replace sealing ring on drain plug.

Tightening Torque,

refer to Technical Data 11 11 5AZ.

Top up coolant. Vent cooling system and check for leaks,

refer to 17 00 005.

Remove timing case covers, top left and right,

refer to 11 14 080 / 11 14 085.

Remove hub for vibration damper,

refer to 11 23 031.

Remove water pump with thermostat housing,

refer to 11 51 000.

Note:

When the liquid-cooled alternator is removed, a residual
quantity of coolant emerges from the timing case cover.

Catch and dispose of residual quantity of coolant.

Remove liquid-cooled alternator.

Remove upper oil sump section,

refer to 11 13 010.

RA  Removing and installing timing case cover, bottom (M62 VANOS from 9/98)

BMW AG - TIS

08.02.2013  01:47

Issue status (12/2007) Valid only until next DVD is issued

Copyright

Page  - 1 -

3 RA Removing And Installing Timing Case Cover, Bottom (M62 VANOS From 9_98)|Page 466 > < 2 RA Removing And Installing Timing Case Cover, Top Right (M62 VANOS From 9_98)|Page 464